Back

Koyo Terminator I/O
Terminator I/O is the flexible cost saving solution for a distributed I/O system, used for e.g. SoftPLC systems, I/O extension to your PLC system or simply as data collection points for an OPC server. You can distribute I/O nodes with Terminator I/O close to the field devices for faster and more efficient wiring and troubleshooting. A full range of network modules are supported, including Ethernet with Host IP and/or Modbus TCP protocol, DeviceNet, Modbus, Koyo remote I/O and Profibus (released autumn 2001).

 

Koyo EBC
Ethernet Base Controller for DL205/405 base, supports discrete and analog I/O.
Supports 10 base-T connections to PC-based controllers, supporting IP/IPX
protocol.

 

Koyo ECOM
Ethernet Communication module, master/slave on an Ethernet 10 baseT
network at 10 Megabaud.

 

Koyo WinPLC
PLC form factor, fits into the CPU slot of DL205 bases • 40 Mhz or 100 Mhz CPU
4 Mbyte of Flash ROM • 2 Mbyte of RAM • Microsoft® Windows CE operating
system • 10Mbps Ethernet communication port • RS-232 port • Think & Do
run-time lic.

 

Copyright © 2006 BRODERSEN AUTOMATION A/S. All rights reserved

Brodersen will accept no liability what so ever regarding any typographical, clerical or other
error or omission on this site.